On FortiGate models with ports at the back of the device, this LED is in the lower row. On FortiGate models with front-facing ports, this LED is to the right of the port. On FortiGate models with ports at the back of the device, this LED is in the upper row. On FortiGate models with front-facing ports, this LED is to the left of the port. A critical alarm (also called an IPMI non-recoverable (NR) alarm) indicates detection of a temperature or power level that is outside of the allowed operating range and could potentially cause physical damage.a high temperature or a high power level) or a lower critical (LC) threshold (e.g. A critical threshold can also be an upper critical (UC) threshold (e.g. temperature) are approaching the outside limit of the allowed operating range. For example, the cooling system cannot provide enough cooling to reduce the temperature. A major alarm (also called an IPMI critical or critical recoverable (CR) alarm) indicates that the system itself cannot correct the cause for the alarm and that intervention is required.The LEDs do not indicate minor alarms since user intervention is not required. A non-critical threshold can be an upper non-critical (UNC) threshold (for example, a high temperature or a high power level) or a lower non-critical (LNC) threshold (for example, a low power level). In the case of a minor temperature alarm, the system could respond by increasing fan speed. A minor alarm (also called an IPMI non-critical (NC) alarm) indicates a temperature or a power level outside of the normal operating range that is not considered a problem.Minor, major, and critical alarms are defined based on IPMI, ATCA, and Telco standards for naming alarms. Wireless interface is transmitting and receiving data. The failover operation feature is not available in all models. The status LED will also be red.įortiGate is operating in an FGCP HA cluster.Ī failover has occurred. No alarms or the FortiGate has a minor alarm. If the FortiGate has a reset button, this could also means that the reset button was used. If the cable is fine, then you should call the service provider (and tell them about the status of the light) because there's nothing you can do on your own at that point to fix the problem.For more information about alarms, see About Alarm Levels. If it's off, red or flashing constantly (it's OK if it flashes for a short time, like less than a minute, after a reboot) then check to make sure the service cable, either the phone line (DSL) or the coaxial cable (cable internet) is securely plugged in and not broken. Under normal conditions, this light should be solid green (or amber). This light is often labeled as Online, Cable, Sync or Signal and usually has a symbol similar to the internet light on a router as mentioned above. Similar to routers, most modems (both Cable and DSL) have a light dedicated to the broadband connection. If the cable is all fine, then it's time to check your cable or DSL modem's light. But if it's off or red in color, then it's time to check to make sure that the network cable that connects the router's WAN (Internet) port (often on the back of the router) to the modem is plugged in securely and not broken in any way. In most cases, this light needs to be lit solid (white, green or amber) or flashing to show that internet activity is happening. This light is often labeled as Internet, WAN, or marked with a symbol of globe or a satellite flying around a globe. Most routers have a single light dedicated solely to the status of the internet connection. When you lose the internet, here's how you can use some of them to troubleshoot the problem. Check your alarm light Is there a red alarm. What isn't obvious is what the hell the purpose of these lights is. 242X User Manual HTML Version Manual Zhone zNID 24xx Series Hardware Inst allation Guide For software version 2. Actually, I was being facetious saying "you may have noticed" because these lights are totally obvious. You may have noticed that your router and modem have, like, a ton of constantly blinking lights on them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |